Feet&Roll Express Electronic Anti-Hardness File

DIRECTIONS FOR USE

1. Wash and dry your feet completely
2. Place the head according to the thickness of the calluses to be removed: Light calluses and final finish: fine grain Medium calluses: medium grain Severe calluses: coarse grain You can also combine different heads during the filing process: Start with the coarse or medium grain head and finish with the fine grain one to achieve smooth and soft skin.
3. Press the power button and the head will start spinning at high speed (red light). If you want to switch to extra fast speed (green light), press the button again.
4. Make rotational movements over the calluses, without applying much pressure, you will see how the dead skin is removed. It is advisable to change areas to achieve a uniform result.
5. Turn off the electronic file by pressing the power button. Check the result; you can run the file again with the fine-grain head until you achieve the desired outcome.
6. After each use, turn off the file and clean it following the instructions in the "Maintenance and Cleaning" section of the FAQs. Important: do not immerse or rinse the main body of the electronic file with water. For hygiene reasons, we recommend not sharing the electronic file with other users.

WARNINGS

Do not use the electronic callus remover:

• In an area of the body other than the feet
• On the skin if there are wounds or it is infected
• About blisters, warts, risk areas (varicose veins, moles, birthmarks) or if you have any skin condition (eczema, inflammations)
• If you suffer from diabetes or poor blood circulation
• If it is plugged into the battery charging cable
• Keep out of reach of children

How to change the printhead

With the electronic file turned off, remove the head by pulling it outward. To place it, fit the head as shown in the image; you will hear a "click" indicating it has been properly installed.

Cleaning and maintenance

Always clean with the file turned off. To open, turn the locking disc counterclockwise. Use the brush to clean the interior. Do not immerse, or use water or abrasive or corrosive products to clean it. To clean the sponge, remove the locking disc from the head and take out the piece with holes. The sponge and the piece with holes can be washed with water; they must be dry before being reassembled. Reattach the locking disc by turning it clockwise, making sure it is in the closed position.

Charging system

It can be charged by connecting the USB cable to a 5V 1A adapter (not included) or to a personal computer. When the indicator is red, the battery needs to be charged. When the indicator changes to green light, it will be fully charged. Make sure to recharge it after each use to maintain the optimal performance of the lithium battery. The full charging time is 2 hours; once charged, it is recommended to disconnect it from the power source.